to our website
Knowledgebase
Back to website > OPTIC, LINEX, PHASER Help Desk > Knowledgebase

Search help:


What should be the minimum and maximum Air pressure for the OPTIC cooling valve?

Solution

The OPTIC inlet is standard cooled with Air, the Air supply to the valve on the back of the OPTIC controller should have a minimum pressure of 1 BAR and maximum of 7 BAR.

For normal operation 5 BAR is advised.

The Air consumption @ 5 BAR is about 40-50 L/min when the cooling valve is open.

 

Part number: 2406-4205 OPTIC-4 Inlet Cooling Valve Assembly 

 

The cooling valve was changed from a round to a square version, this was done because the round version was no longer produced.

 

The direction of the Air flow is important for the valve. Please connect the tubes in the correct way!

When  replacing the valve, please take care to install it as shown on the right picture.

 
Was this article helpful? yes / no
Related articles Do I need Peltier cooling with the OPTIC inlet?
the film of the column is gone at the entrance and the exit of the cryotrap.
CryoTrap cannot reach low setpoint
CryoTrap temperature is not stable, what you be the problem.
I have unstable flows and pressure, what could this be?
How can I do floating of Inlet temperature in Expert Method?
How often do I need to replace the Split Line Filter?
Split flow measured at the Exhaust is wrong.
Article details
Article ID: 26
Category: OPTIC
Rating (Votes): Article rated 3.0/5.0 (4)

 
« Go back

 
Powered by Help Desk Software HESK, brought to you by SysAid