to our website
Knowledgebase
Back to website > OPTIC, LINEX, PHASER Help Desk > Knowledgebase

Search help:


How can I do floating of Inlet temperature in Expert Method?

Solution

In the Expert Method there is no selection for Temperature Control (Keep Until End / Floating). So it looks like it is not possible to make a floating temperature. The way to do this is simple, just make an extra temperature step and with the option of Cooling Valve Mode set to No you will have a floating temperature of the inlet.

 

 
Was this article helpful? yes / no
Related articles Is it possible to make an EGA thermogram with OPTIC?
Leak at the head of the LINEX / head does not close fully.
Errors and Warnings / OPTIC-4
I am not sure what liner I should use.
What is the difference between; 'LINEX-Liquid Injection' and 'LINEX' method?
The Inlet or CryoTrap won’t heat up and the value remains 0 / zero
I want to add a temperature step in the Expert Method, but cannot do this because it is greyed out.
How can I optimize my Large Volume Injection (LVI) ?
Article details
Article ID: 49
Category: OPTIC
Rating (Votes): Article rated 3.0/5.0 (4)

 
« Go back

 
Powered by Help Desk Software HESK, brought to you by SysAid